M10 X 1.25 Titanium Strut tower nuts

FeltyFab’s titanium strut tower nut kits are engineered for serious performance. Machined from forged Ti-6Al-4V aerospace-grade titanium, these nuts feature wide flanges for increased contact area—delivering improved load distribution and clamping force across your strut mounts. Whether you're dialing in suspension geometry or upgrading corroded factory hardware, these are true performance fasteners, not decorative dress-up pieces.

Key Features:
-Aerospace-grade forged titanium construction
-45% lighter than steel
-Wide flange design for enhanced contact and stability
-Superior corrosion resistance and heat tolerance
-Optional titanium “bucket” washers available via dropdown selection
-Sold as a 4-pack (order two kits for front and rear struts)

Compatible with vehicles using M10x1.25 strut tower studs, including:
-Acura
-Most Datsuns
-Most Hondas
-Mitsubishi Lancer
-MK3 & MK4 Toyota Supra
-Mazda RX-7 & RX-8
-Nissan S-chassis …and more. Always verify your thread pitch before ordering.

Important Notes:
-Not all Honda/Acura models use M10x1.25. Many aftermarket coilovers use M10x1.5. Triple-check your thread pitch before purchase.
-FeltyFab titanium products are raw metal. They are not anodized or coated with paint or oil. Hydrochloric acid will damage titanium surfaces. Ensure your cleaners are acid-free. FeltyFab is not responsible for discoloration caused by improper care or washing.

Engineered for strength. Built for precision. Titanium that performs.